bouton-led.ino
The button is read through an external interrupt: no press is lost even when loop() is busy. A 30 ms filter inside the ISR removes bounce, and the noInterrupts section guarantees a coherent counter read.
Hardware
A Teensy 3.2 (NXP Kinetis MK20DX256, Cortex-M4 @ 72 MHz, 3.3 V logic) powered over USB. 1 push button to GND.
Wiring
Button between pin 2 and GND (internal resistor enabled by INPUT_PULLUP). All pins are interrupt-capable on Teensy.
How it works
attachInterrupt() hooks the falling edge; the ISR increments a volatile counter. loop() prints the counter and lights the LED on odd counts.
Running it
Install the Teensyduino plugin in the Arduino IDE, select the « Teensy 3.2 » board, click Upload then the Teensy Loader button. Note: 3.3 V pins.
Variants
Add a « reset » button, or send the count over MIDI (Note On) as a drum-machine trigger.
bouton-led.ino
// Compteur d'appuis : bouton sur interruption externe (EXTI).
const int BOUTON = 2; // broche interruptible (tout pin Teensy l'est)
const int LED = 13;
volatile unsigned long compteur = 0;
volatile unsigned long dernierFront = 0;
void surAppui() {
unsigned long maintenant = millis();
if (maintenant - dernierFront < 30) return; // anti-rebond 30 ms
dernierFront = maintenant;
compteur++;
}
void setup() {
pinMode(BOUTON, INPUT_PULLUP);
pinMode(LED, OUTPUT);
attachInterrupt(digitalPinToInterrupt(BOUTON), surAppui, FALLING);
Serial.begin(9600);
Serial.println(F("Compteur d'appuis pret"));
}
void loop() {
static unsigned long derniereAffichage = 0;
if (millis() - derniereAffichage < 200) return;
derniereAffichage = millis();
noInterrupts(); // lecture atomique de la variable 32 bits
unsigned long n = compteur;
interrupts();
digitalWrite(LED, (n % 2) ? HIGH : LOW);
Serial.print(F("appuis = ")); Serial.println(n);
}