sommeil-basse-consommation.ino

Particle Boron · File : sommeil-basse-consommation.ino · Language : Arduino · Use case : Réveil périodique en mode Stop pour fonctionner sur batterie

The battery survival cycle: wake, DHT reading, cloud publish, then 60 s deep sleep with the radio off. Restarting each cycle simplifies the firmware at the cost of a cloud reconnect — the classic coin-cell sensor trade-off.

Hardware

A Particle Boron module (nRF52840, Wi-Fi + Bluetooth LE, cellular variant where applicable) with on-board antenna. 1 DHT11 sensor + LiPo battery (the module handles charging on its VUSB/VIN pin).

Wiring

DHT on D5 as in the sensor example; battery on the LiPo pads. External antenna if the enclosure is metal.

How it works

System.sleep(SLEEP_MODE_DEEP, 60) cuts everything but the wake timer; the board restarts from setup() on wake. WiFi.off/Cellular.off avoid residual radio draw.

Running it

Install the Particle CLI (particle setup), flash with particle flash --serial or OTA (particle flash <name> firmware.bin). The Device Cloud app or REST API complete the deployment.

Variants

External interrupt wake (interrupt on D2 for a detector), or adaptive: lengthen sleep while the reading is stable.

sommeil-basse-consommation.ino

// Cycle basse consommation : mesure, publication, Stop 60 s.
// Le lien cloud est coupe pendant le Stop (reconnexion au reveil).

#include "DHT.h"
DHT dht(D5, DHT11);

void setup() {
  Serial.begin(9600);
  dht.begin();
  Particle.process();          // laisse la connexion s'etablir
}

void loop() {
  // 1) Rejoindre le cloud (bloquant jusqu'a 10 s).
  if (!Particle.connected()) Particle.connect();

  // 2) Mesurer et publier.
  dht.measure();
  char trame[64];
  snprintf(trame, sizeof(trame), "{\"t\":%.1f,\"h\":%.1f}",
           dht.readTemperature(), dht.readHumidity());
  Particle.publish("mesure-batterie", trame, 60, PRIVATE);

  // 3) Endormissement : radio eteinte, courant divise.
  Serial.println("Endormissement 60 s...");
  Serial.flush();
  WiFi.off();
  Cellular.off();   // ignore sur les modeles sans cellulaire
  delay(100);
  System.sleep(SLEEP_MODE_DEEP, 60);  // deep sleep 60 s

  // Au reveil, la carte redemarre depuis setup() :
  // le cycle complet se repete a chaque reveil.
}

// Sur batterie 180 mAh, le deep sleep entre deux publications
// fait tenir des semaines ; verifier le courant reel de sa variante.

← Back to the board