dht22.ino
The DHT22 delivers temperature and humidity over a single wire: the Adafruit library decodes the 40-bit frames and the sketch adds the dew point. The 2 s cadence is the sensor's hard limit.
Hardware required
An ESP32-C6 board (RISC-V 160 MHz, Wi-Fi 6 + BLE 5 + 802.15.4) such as a DevKitC-1, powered over USB. 1 DHT22 (3-pin module with built-in pull-up) or bare DHT22 + 10 kΩ.
Wiring
VDD 3.3 V, DATA on GPIO4 with 10 kΩ pull-up to 3.3 V, GND. The DHT11 also works (change DHTTYPE).
How it works
readTemperature/readHumidity run a full acquisition (start bit + 40 timed bits). The sensor is slow, so loop passes are skipped until 2 s; NaNs flag a lost frame. In the Arduino IDE (recent esp32 package), select « ESP32C6 Dev Module » then Upload; for Zigbee/Thread use ESP-IDF (idf.py set-target esp32c6).
Going further
Show on the OLED of the next sketch, or publish readings over BLE/Wi-Fi to a dashboard.
dht22.ino
// DHT22 sur GPIO4 — bibliothèque « DHT sensor library » (Adafruit).
#include <DHT.h>
#define DHTPIN 4
#define DHTTYPE DHT22
DHT dht(DHTPIN, DHTTYPE);
unsigned long precedent = 0;
void setup() {
Serial.begin(115200);
dht.begin();
Serial.println("DHT22 pret (2 s entre mesures)");
}
void loop() {
if (millis() - precedent < 2000) return; // le DHT22 parle au mieux à 0,5 Hz
precedent = millis();
float t = dht.readTemperature();
float h = dht.readHumidity();
if (isnan(t) || isnan(h)) {
Serial.println("Echec de lecture : cabling/alimentation ?");
return;
}
float dew = 243.04 * (17.625 * t / (t + 243.04) + log(h / 100.0))
/ (17.625 - (17.625 * t / (t + 243.04) + log(h / 100.0)));
Serial.printf("T=%.1f C HR=%.1f %% point de rosee=%.1f C\n", t, h, dew);
}